详细说明
| Output VoltageTD | Output Current Min. | Output Current Max. | Regulation Load | Regulation Line | Output Ripple & Noise Max.[P-P] |
| +5V | 1 | 32 | ± 5% | ± 50mV | 50mV |
| +12V | 2 | 42 | ± 5% | ± 50mV | 70mV |
| -12V | 0 | 1 | ± 5% | ± 50mV | 70mV |
| +3.3V | 1 | 24 | ± 5% | ± 50mV | 50mV |
| +5VSB | 0.1 | 2 | ± 5% | ± 50mV | 50mV |
*TEMPERATURE RANGE: OPERATING 0℃～40℃，STORAGE -20℃～70℃
* HUMIDITY:OPERATING:20%-95%, NON-OPERATING:10%-95%
* REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS
*HOLD UP TIME: 16mS MIN. AT FULL LOAD & 90 VAC INPUT VOLTAGE
*DIELECTRIC WITHSTAND: INPUT/OUTPUT 1500 VAC FOR 1 minute
INPUT TO FRAME GROUND 1500 VAC FOR 1 minute
*EFFICIENCY: 65% TYPICAL，AT FULL LOAD
*POWER GOOD SIGNAL: ON DELAY 100mS TO 500mS，OFF DELAY 1mS
*OVER POWER PROTECTION: 110% ~ 150%
*OVER VOLTAGE PROTECTION: +5V -> 5.7V ~ 6.5V, 3.3V -> 3.7V ~ 4.3V +12V -> 13.3V ~ 15V
*SHORT CIRCUIT:5V,12V,3.3V 130%±20% AT FULL LOAD
*EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B
*SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
*REMOTE ON/OFF CONTROL
*FAULTY ALARM METHODS:LED , BUZZER, TTL SIGNAL
*MEET IEC-1000-3-2 CLASS D (ACTIVE PFC)
*HOT-SWAPPABLE/HOT PLUGGABLE REDUNDANCY FUNCTION
*REMOTE SENSING DESIGN
*ISOLATION: BUILT-IN THE POWER MODULE
*COOLING: TWO 38mm DC FAN (MODULE)
*AC INLET IN EACH MODULE
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
关闭返回