P3M-9950P(950W)

详细说明

950W

Server ,Workstation ,Storage System ,IPC ,Communication

Dimension....

300x100x127(mm)
11.81x3.93x5(inch)

AC Input Spec...

VOLTAGE: 100V ~ 240VAC (WITH ± 10% TOLERANCE)
FREQUENCY: 47Hz ~ 63Hz
INPUT CURRENT: 10A/5A AY ANY LOW/HIGH RANGE INPUT VOLTAGE
INRUSH CURRENT: 140/160A @ 110/220VAC (25℃)
POWER FACTOR CORRECTION: 95% @ 230V, FULL LOAD

DC Output Spec..

Output VoltageTD	Output Current Min.	Output Current Max.	Regulation Load	Regulation Line	Output Ripple & Noise Max.[P-P]
+5V1	3.0	25	± 5%	± 50mV	80mV
+5V2	2.5	35	± 5%	± 50mV	80mV
+12V1	2.0	28	± 5%	± 50mV	120mV
+12V2	2.0	42	± 5%	± 50mV	120mV
-5V	0	0.8	± 5%	± 50mV	100mV
-12V	0	1.0	± 5%	± 50mV	100mV
+3.3V1	0	20	± 5%	± 50mV	80mV
+3.3V2	1.0	30	± 5%	± 50mV	80mV
+5VSB	0.1	2	± 5%	± 50mV	80mV

Features...

‧TEMPERATURE RANGE: OPERATING: 0℃ --- 40℃ STORAGE: -20℃ --- 80℃
‧HUMIDITY:OPERATING:20%-95%, NON-OPERATING:10%-95%
‧REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS
‧HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
‧DIELECTRIC WITHSTAND: INPUT / OUTPUT 1800 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1800 VAC FOR 1 SECOND
‧ EFFICIENCY: 70% TYPICAL AT 115VAC FULL LOAD
‧POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
‧OVER POWER PROTECTION: 110% ~ 150%
‧OVEROVER VOLTAGE PROTECTION: If an over voltage fault occurs，the power supply will latch all DC output into a shutdown state.

	Min	Typical	Max
+3.3V1	3.7V	4.1V	4.3V
+3.3V2	3.7V	4.1V	4.3V
+5V1	5.7V	6.1V	6.5V
+5V2	5.7V	6.1V	6.5V
+12V1	13.6V	14.3V	15V
+12V2	13.6V	14.3V	15V

OVER CURRENT PROTECTION: If an over current fault occurs，the power supply will latch all DC output into a shutdown state.

	Min	Typical	Max
+3.3V2	33A	39A	45A
+5V2	38.5A	45.5A	52.5A
+12V2	46.2A	54.6A	63A

‧SHORT CIRCUIT PROTECTION: +5V1,+5V2, -5V, +12V1,+12V2, -12V, +3.3V1,+3.3V2
‧EMI NOISE FILTER: FCC CLASS B CISPR22 CLASS B
‧REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABL

*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.

这里已调用系统的信息评论模块,无需修改!

这里已调用系统的评论列表模块,无需修改!

上一条: P2H-5500G(500W) 下一条: P1H-5420G(420W)

最新动态

P3M-9950P(950W)