详细说明
| Output VoltageTD | Output Current Min. | Output Current Max. | Regulation Load | Regulation Line | Output Ripple & Noise Max.[P-P] |
| +5V | 0.5 | 32 | ±5% | ±1% | 50mV |
| +12V | 2 | 55 | ±5% | ±1% | 120mV |
| -12V | 0.05 | 0.8 | ±5% | ±1% | 120mV |
| +3.3V | 0.5 | 36 | ±5% | ±1% | 50mV |
| +5VSB | 0.1 | 3.5 | ±5% | ±1% | 50mV |
* TEMPERATURE RANGE：OPERATING 0℃～50℃，STORAGE -20℃～80℃
* HOLD UP TIME：1mS MIN. AT FULL LOAD
* DIELECTRIC WITHSTAND：INPUT/OUTPUT 1500 VAC FOR 1 minute INPUT TO FRAME GROUND 1500 VAC FOR 1 minute
* EFFICIENCY：80% TYPICAL，AT INPUT -48V FULL LOAD
* POWER GOOD SIGNAL：ON DELAY 100mS TO 500mS，OFF DELAY 1mS
* OVER POWER PROTECTION：110～150% MAX
* OVER VOLTAGE PROTECTION：+5V→5.7V～6.5V，+3.3V→3.9V～4.3V ，+12V→13.3V～14.3V
* SHORT CURRENT PROTECTION:+5V,+12V,+3.3V
* EMI : FCC CLASS A , CISPR 22 CLASS A
* SAFETY：TO MEET UL, CUL, TUV
* REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
AS LOGIC LEVEL IS LOW，OUTPUTS VOLTAGE WERE ENABLE， AS LOGIC LEVEL IS HIGH，OUTPUTS VOLTAGE WERE DISABLE.
* COOLING: TWO 38x38x28mm DC FANS
* DC INLET IN EACH MODULE
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
关闭返回