VOLTAGE： 100～240VAC FULL RANGE FREQUENCY： 50～60HZ INPUT CURRENT：5A（RMS）FOR 230VAC 13A（RMS）FOR 115VAC INRUSH CURRENT：110A MAX. FOR 115 VAC PER MODULE 150A MAX. FOR 230 VAC PER MODULE
DC Output Spec...
Output VoltageTD
Output Current Min.
Output Current Max.
Regulation Load
Regulation Line
Output Ripple & Noise Max.[P-P]
+5V
2
52
±5%
±1%
50mV
+12V
3
56
±5%
±1%
120mV
-12V
0.1
1
±5%
±1%
150mV
+3.3V
1
40
±5%
±1%
50mV
+5VSB
0.1
3.5
±5%
±1%
50mV
TOTAL CURRENT OF +5V AND +3.3V NOT EXCEED 70A
Features...
*TEMPERATURE RANGE：OPERATING 0℃～40℃，STORAGE -20℃～70℃ * HUMIDITY:OPERATING:20%-95%, NON-OPERATING:10%-95% * REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS *HOLD UP TIME：16mS MIN. AT FULL LOAD & 90 VAC INPUT VOLTAGE *DIELECTRIC WITHSTAND：INPUT/OUTPUT 1500 VAC FOR 1 minute INPUT TO FRAME GROUND 1500 VAC FOR 1 minute *EFFICIENCY：65% TYPICAL，AT FULL LOAD *POWER GOOD SIGNAL：ON DELAY 100mS TO 500mS，OFF DELAY 1mS **OVERLOAD PROTECTION：110～160% MAX *OVER VOLTAGE PROTECTION：+5V→5.7V～6.7V，+3.3V→3.7V～4.7V ，+12V→13.0V～15.0V *SHORT CIRCUIT: 5V,12V,3.3V, AUTO-RECOVERED: 5VSB,-12V * EMI : FCC CLASS B , CISPR 22 CLASS B *SAFETY：UL 60950, CB IEC60950, TUV EN60950 *REMOTE ON / OFF CONTROL *FAULTY ALARM METHODS: LED, BUZZER, TTL SIGNAL *MEET IEC-1000-3-2 CLASS D (ACTIVE PFC) *2 +1, HOT-SWAPPABLE / HOT PLUGGABLE REDUNDANCY FUNCTION *N +1 BALANCE LOAD SHARING DESIGN ON 5/12/3.3V CHANNEL * REMOTE SENSING DESIGN * ISOLATION: BUILT-IN THE POWER MODULE *COOLING: THREE 40mm DC FANS (ONE IN EACH MODULE)
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
关闭返回